3DSL Enhancements

1. Reverted a change introduced in V2021.0630 which would reuse the matrix setup when recalling SAMG within a timestep.  The setup is no longer reused when SAMG is recalled.  This may slightly increase runtimes for some models but will avoid excessive runtimes when there are substantial numbers of wells backflowing.  

3DSL Bug Fixes

1. When reading the FAULTS keyword, an out of memory error would occur if a fault contained more than 32,000 separate line entries.

3DSL Enhancements

1. Modified the bulk volume calculation for CPG cells to be identical to studioSL and to Eclispe 100 (See the section CPG Grids – Porevolume Calculation for details).  Note that 3DSL only computes the bulk volume for gridcells if the PORV keyword is not present in a .INIT file.

3DSL Bug Fixes

Grid Builder

floodOPT

1. Updated Windows executable to version 2021.0701.

3DSL simulator

1. Updated Linux executable to version 2021.0730.

Grid Builder

1. When interpolation Zmap points to grid cell properties, ignore null values of the 4 Zmap points that surround the grid cell center point of interest. Only set the grid cell center point of interest to null if all Zmap points are null.  Previously, if any of the 4 points were null, then the grid cell center point was assigned null too.  This will reduce the number of grid cell points that have null values compared to the previous release.

General

1. Fixed possible threading deadlock when using toolpanel controls.

ECLIPSE support in floodOPT

1. Always add UNIFIN in RUNSPEC when creating an ECLIPSE main file suitable for export streamlines with 3DSL.

floodOPT

1. Updated to version 2021.0630.
2. "Other Settings" section renamed to "Output Settings" and now supports using different control modes for producers and injectors. 
3. Support for reading well bottom-hole pressures from the basecase or previous run to use as control or limit when writing to schedule/recurrent file.

Differential Evolution

3DSL executable

1. Updated 3DSL Linux executable to 2021.0602

floodOPT

1. Fixed several exceptions when workflow location is somehow missing.

CMG support

1. Added support for temperature sequences in 2D plot.
2. Fixed support in multiRUNS project allowing to color by parameter and have GSA plot working properly.
3. Fixed support for run state by reading .out file.

Parsers

1. Improved performance on reading .SLNnnnn files for streamlines geometry in 3D.

3D Viewer